Fuse box Lada Grants and designation
All parts and components of the electrical circuit of the Lada Granta car are protected by fuses. This is necessary so that in the event of an excessive load or short circuit, the fuse will take the entire blow, and the main device will remain intact and unharmed.
Where is the fuse box on Grant
The location of the block is approximately the same as on the previous model - Kalina. That is, on the left side near the light control unit. To show all this more clearly, below will be a photo of its location:
Each fuse seat in the mounting block is designated by Latin letters F under its own serial number. And which fuse is responsible for what, you can see in the table below.
This scheme is presented from the official website of the manufacturer Avtovaz, so you should take it with confidence. But nevertheless, it should be borne in mind that, depending on the configuration and version of the car, the mounting blocks may be slightly changed and the arrangement of the fusible elements is not the same as shown below.
But such cases are extremely rare, so you can navigate by the table below.
| Fuse No.nitel | Forcecurrent, A | Protected electrical circuits |
| F1 | 15 | controller, engine cooling fan relay, short circuit 2x2, injectors |
| F2 | 30 | window lifters |
| F3 | 15 | Emergency Signal |
| F4 | 20 | wiper, airbag |
| F5 | 7,5 | 15 terminal |
| F6 | 7,5 | reverse light |
| F7 | 7,5 | adsorber valve, DMRV, DK 1/2, speed sensor |
| F8 | 30 | heated rear window |
| F9 | 5 | side light, right |
| F10 | 5 | side light, left |
| F11 | 5 | rear fog light |
| F12 | 7,5 | low beam right |
| F13 | 7,5 | low beam left |
| F14 | 10 | high beam right |
| F15 | 10 | high beam left |
| F20 | 15 | horn, trunk lock, gearbox, cigarette lighter, diagnostic socket |
| F21 | 15 | gasoline pump |
| F22 | 15 | central locking |
| F23 | 10 | DRL |
| F25 | 10 | interior lighting, brake light |
| F32 | 30 | heater, EURU |
The mounting block contains a pair of tweezers, which are designed specifically to remove blown fuses. If you cannot remove them with the help of them, you can pry the fuses gently with a flat-blade screwdriver.
It is worth noting that instead of the failed fuses on the Grant, it is necessary to strictly set only the rated current strength, otherwise two ways of developing events are possible:
- If you put less power, they can constantly burn out.
- And if you put on the contrary more power, then this can lead to a short circuit and fire in the wiring, as well as the failure of certain electrical elements.
Also, you should not install self-made jumpers instead of fuses, as many are used to doing, this can cause the electrical system to fail.
