How to adjust the throttle cable on a motorcycle?

Adjust the motorcycle throttle cable. this is one of the simplest tasks. If you have the necessary tools, namely open-end wrenches, you can adjust it in about ten minutes.

Where can I find an accelerator cable? How do I know if the cable is faulty? How do I make the necessary adjustments? Check out our tips on how to properly adjust your motorcycle throttle cable.

How do you find the accelerator cable on his motorcycle?

The throttle cable on a motorcycle is easy to find. It turns out that in the gas grip, that is, with the correct grip, which you obviously use for acceleration. If this handle only contains one cable, this is the one you are looking for.

However, it is possible that it contains two. In this case, the throttle cable is usually at the top. Another cable, that is, the bottom one, serves as a security. It's there to make sure the throttle is back in place when you release it. For this he was nicknamed the return cable.

How to adjust the accelerator cable of your motorcycle?

First of all, please note that it is not necessary to adjust the throttle cable unless it is hazardous. Before touching anything as a result, first check if there is a problem. Then you can make the necessary settings.

How do I know if the cable is faulty?

Normally, the throttle cable is activated when the grip is turned. This action will actually pull on the cable, which will cause the motorcycle to accelerate. However, this reaction does not happen almost instantly. If you have been riding for a long time, you will notice a slight delay between the moment you turn the handle and the moment the motorcycle actually presses the gas pedal. This is completely normal.

However, it fails when it waiting time becomes unusually long... If you feel like the throttle is not responding for a long time, if you feel like you are cranking it straight out due to poor response, this is a problem. And this, especially when cornering or when driving in roundabouts. This usually means that the throttle cable is worn out and you need to adjust the protection.

How to adjust the throttle cable of a motorcycle?

It's very simple and hopefully you don't even have to touch the throttle. To find out if you need to tighten or loosen the cable, turn the handlebar all the way in the desired direction and slightly pull on the cable cover. If you don't notice any slack, it means that you need to loosen the motorcycle throttle cable. If the slack is more than 1 millimeter, it means that you need to tighten the cable.

To make the necessary adjustments, take a key for 8 and a key for 10... Lock the adjusting nut first and unscrew the lock nut with the second. Then adjust as needed: loosen the adjusting nut to loosen and tighten to tighten. And this is until you get the right guard. And when this is done, tighten the long nut with a wrench 8 and tighten the lock nut.