How to use a Makita drill

Makita drills are very individual and efficient. In this article, I will teach you how to use them correctly.

The Makita drill is one of the most efficient and user-friendly tools. Knowing how to properly operate your Makita drill will make every DIY project you do easier. In addition, understanding how to confidently use a drill will help you avoid injury from flying projectiles or careless handling of the tool.

To properly use your Makita drill:

• Wear protective equipment such as eye and ear protection.
• Engage the clutch
• Set the drill
• Secure metal or wood
• Apply light pressure while adjusting the clutch for acceleration.
• Let the drill cool down

I'll go into more detail below.

Using a Makita drill

Step 1: Wear protective gear such as eye and ear protection.

Put on protective gear and goggles before using a Makita drill, whether electric or handheld. If you have long hair, tie it up and don't wear any jewelry or anything too baggy. You don't want clothes or hair stuck in the drill.

Also, wear safety goggles or goggles that will protect your eyes from flying particles or tiny pieces of material.

Step 2: Engage the clutch

Set your Makita drill to screwdriver mode. Then engage the clutch with numbers 1 to 21 in different positions.

The drill has two speeds to choose from, so you can accurately determine the right amount of torque, power and speed.

Step 3: Purchase an Impact Gold titanium drill (recommended but not required)

The Impact Gold titanium drills in Makita drills are built for speed and a quick start! You get flawless holes every time you use a 135 degree split point. Titanium coated bits last up to 25% longer than conventional uncoated bits.

Step 4: Insert the drill

Always make sure the drill is off before inserting the drill. Replace the drill by releasing the drill in the chuck, replacing the drill, and then tightening it again after the drill has been turned off and disconnected.

Step 5: Clamp the Metal or Wood You Want to Drill

Before drilling a hole, always make sure that the materials you are drilling into are securely fastened, either clamped, or you are holding them tightly to prevent loose materials from flying out and injuring your hand. This is especially important if you are drilling incredibly small materials. Try not to drill while holding the material with one hand, as the drill can easily slip off and hurt you.

Step 6: Apply constant pressure to the drill

Regardless of the substance you are drilling into; you must hold the drill steady and carefully insert it. You are probably using the wrong drill if you need to apply more force than the drill's minimum pressure. In this case, replace the drill bit with another bit that is better suited to the material you are drilling.

Step 7: Increase Power by Adjusting the Clutch

The grip needs to be adjusted if you have trouble cutting through material. In addition, the sleeve can be replaced to reduce the power of the power tool if you drill the screws too deep into the wood. By adjusting the auger sleeve, you can achieve the depth you need.

Step 8. Use the reverse switch on your Makita drill.

The ability to drill clockwise or counterclockwise is provided in all electric drills. Drill a pilot hole, then press the switch just above the trigger to change the drill's direction of rotation. This will make it easier for the drill to exit the hole and prevent damage to the drill or material.

Step 9: Don't overheat the drill

The drill will experience a lot of friction when drilling through hard materials or at very high speeds. The drill can become very hot, so hot that it can burn out.

Run the drill at moderate speeds to prevent the drill from overheating, and increase the speed only if the Makita drill does not cut through the material.

Take a look at some of our articles below.

• How to connect the dryer motor for other purposes
• How to drill titanium
• What are pointed drill bits used for?