How to properly shift gears on a motorcycle?

Correct gear shifting on a motorcycle necessary if you do not want to prematurely damage the box. Of course, the transition from one report to another does not require special skills. But you should know that there are several parameters to consider, and this must be admitted, it also takes some experience with motorcycles that have speed to be able to master it.

How to engage first gear with the engine off? How to shift from one gear to another with the engine running? Learn how to properly shift gears on your motorcycle.

All about the motorcycle gearbox

First of all, you should know that on a motorcycle the speed is set from the left side of the engine. It is operated with your foot using a lever called a "selector". This pressure is on the latter, which allows you to change gears.

Also note that the field motorcycle speed "sequential"... This means that, unlike a manual transmission in a car, you will not be able to select any gear depending on the engine speed. On a bike, everything is done gradually. If you are in first place and want to move to fourth, you must pass 2 and 3.

Finally, in order to properly shift gears on a motorcycle, you must know how to operate the clutch lever. Depending on what you really need to do, you may need to:

• Disconnect, which means you have to push the lever
• Turn on, which means you need to release the lever

How to properly shift gears on a motorcycle?

Whichever gear you choose to properly shift gears on your motorcycle, you generally need to do the following: Disengage, engage the selector with light pressure on it, release when the desired gear is engaged, and engage the clutch.

How to shift into first gear when starting off?

As in the case of a car, to start driving, you must engage first gear. To activate it, you need press the selector and point it down... Once the transmission is on, you must turn it on. But be careful: if you release the clutch lever too early, you will stall.

To avoid this, here's a catch: When the bike starts to move forward, instead of letting go, hold the lever in its position so that you continue to engage by lightly pressing the gas pedal.

Proper gear shifting on a motorcycle - how to shift to a higher gear?

Don't worry, you won't have any problems shifting gears on the road. To activate higher gears, you must press the selector, but this time pushing it up... To get through successfully, start by disengaging the throttle and disengaging the clutch. Then engage the selector, turn on and increase the speed.

However, the rules remain the same: you should only release the pressure after you pick up the desired speed. The more you insist, the more the speed will increase to the fifth or sixth.

Change gears correctly on the motorcycle in retrograde or stationary mode.

Do you want to stop? In order not to abuse your braking system and then your gearbox, you must first downshift.

How to properly shift and brake on a motorcycle?

You will aim to directly cut the throttle, disengage it, engage the selector, and engage it before braking. It will work, of course, but you risk damaging the sprocket. For successful braking, you should do the following:

• Brake carefully
• Unplug and put on some gas
• Move the selector into a lower gear.
• Engage so that the engine brake is applied.

As a general rule, if you do everything right, that is, if you manage to find the right balance between these 4 actions: disengagement, throttle, selector and clutch, the bike will stop by itself - the same thing.

Proper gear shifting on a motorcycle - how to find neutral?

Dead point between first and second gear... You will have a little trouble finding it at first, because if you push too hard, you will be the first. The secret is to move slowly, press lightly. To shift into neutral, you must brake first. After stopping, you must disengage and activate the selector by lightly pushing down on it.