How do I drain the water from my motorcycle?

Drain the motorcycle recommended at least once a year. In the case of a two-wheeled vehicle, oil is used for more than just lubrication and minimizing the effect of friction. It also protects the engine from corrosion, overheating and contamination.

For these reasons, oil - extremely loaded, full of dirt and metal residue - eventually wears out too. And if it's not replaced quickly, your bike won't perform the way you want it to. Worse, other, more serious problems may arise. The good news is that changing the oil is easy. Of course, you can entrust this to a professional mechanic. But since the operation is quite simple, you can do it yourself in less than an hour.

How do I change the engine oil of your motorcycle? Learn how to drain your motorcycle.

Motorcycle Oil Change - Practical Information

Before emptying your motorcycle, you must first ensure that you have the necessary supplies. Also, do not forget to do this according to the regularity recommended by the manufacturer.

When to drain the motorcycle?

The motorcycle must be drained systematically. from 5 to 10 km depending on the model. Some two wheels need to be emptied up to twice a year, while others only need to be emptied once.

It also depends on how often you use your gear. If it is used frequently, more than 10 km per year, the automatic oil change should be performed more regularly. In all cases, the best way to know the correct intervals and change the oil in a timely manner is to refer to the manufacturer's instructions in the manual.

Tools needed to dry a motorcycle

Before you start draining, make sure you have the following tools:

• Funnel and container for collecting used oil.
• One wrench to loosen the drain plug and one wrench for the oil filter.
• Rags, rubber gloves and possibly safety glasses (optional)

Of course, you will also need a new filter and, of course, spare oil. Make sure it is compatible with your engine and you have enough. If in doubt, always refer to the manufacturer's manual or use the same oil that you intend to replace.

How do I drain the water from my motorcycle?

After all this time, the oil can become thick and viscous. If you don't want to have any problems with deleting, take a moment to do warm up the engine a few minutes before draining... Hot oil will be thinner and flow easier. Once the engine has warmed up, place the motorcycle on a stand and turn off the engine. Then serious business can begin.

Step 1: Draining the used oil

Take a rag or newspaper and spread it over the underside of your motorcycle. Take a container and place it on top, just below the drain nut. Then take a wrench and loosen it.

The oil will begin to drain into the container. Be careful not to touch it, it may be hot and hurt you. So wait a few minutes as the tank may take a while to completely empty... And, having done this, we put the drain plug in place.

Step 2: Replacing the oil filter

If you are unsure where the oil filter is located, take a look at the manual. Once you find it, use the appropriate wrench to remove it, keeping in mind the order in which you removed all related items.

After removing the old filter, take a new one. Clean its base so that it can easily enter the engine, and lubricate the seal with oil to facilitate tightening. Then reinstall it by following the same procedure as removing the old one, but in reverse order. Make sure it is tight.

Step 3: oil change

Take a funnel and use it to pour in new oil. To avoid overflow, measure ahead (referring to the manual as usual) so that you only add what is needed.

Nevertheless, keep a close eye on the pressure gauge make sure that the crankcase is completely filled and that the maximum permissible level is not exceeded. Then close the container with a lid.

Step 4: Checking the oil level

Finally, when you are sure everything is in place and tight, start the engine. Let it run for a few minutes and turn it off. check oil levelif it's lower than the recommended one, add more.