How to remove or replace the jumper?

	Over time, lintels (bearing supports) may crack or expand and need to be replaced. This requires the use of support legs to hold the weight over the lintel during its replacement.
	Step 1 - Cut with Mortar First, cut the mortar between the bricks above the lintel. Here you can insert supports with masonry supports. Place the props on the ground, extend them to the desired height and secure by inserting a pin into the collar.
	Step 2 - Insert masonry supports and supports. Hammer the back of the masonry support until it is about two-thirds through the masonry. Make sure the supports are fully secured by checking that they are not loose.
	Step 3 - Remove the bricks Remove bricks around the lintel and remove excess mortar.
	Step 4 - Remove and Replace the Jumper The jumper can then be removed and replaced.
	Step 5 - Replace the bricks Replace and refill the bricks around the new lintel, making sure they go further than the lintel on the sides to make sure it's secure.
	Step 6 - Leave 24 hours Wait 24 hours for the mortar to dry, then remove the supports and masonry fixtures, finally sealing the gaps made for them.