How to drive screws into a concrete wall without a drill
In this guide, I will teach you how to drive screws into a concrete wall without a drill.
As an electrician, I am well aware of the methods used to drill holes in concrete walls with a nail, hammer, or screwdriver. However, concrete walls are strong, so you will need a strong screwdriver and steel nails to penetrate.
Quick Overview: Follow these simple steps to drive screws into a concrete wall without a drill:
- Find a nail. The nail should be smaller than the screw.
- Pierce the wall with a nail and hammer. Make sure the nail is driven deep into the wall to leave a neat hole.
- Remove the nail with the nail side of the hammer.
- Insert screw
- Adjust screw
I'll tell you more below.
Note. Below I will show you a guide on how to do this and then insert an anchor for various purposes, such as hanging pictures.
Procedure
Step 1: Make a Small New Hole with a Nail
First, I recommend that you make a new hole with a hammer, a standard Phillips screwdriver, a nail, and pliers.
Use a pencil or a nail to mark the area on the wall where you want the screws to go. Then hammer the nail into the wall until you have a nice hole. Don't forget to grab the nail with the pliers. This way you won't accidentally touch your fingers.
Once the hole is deep enough, pull out the nail with the claw side of the hammer.
Step 2: Tighten the screw
The extra space created by the hole you've driven in with the nail will make it much easier to drive the screw.
Be careful not to overdo or overwork the screwdriver and inadvertently pierce the walls with it. A screwdriver can also bend a piece of drywall. You have to walk carefully if you want a neat opening.
Step 3: Insert the Drywall Anchor
After that, thread the drywall anchor through the hole and secure it.
To ensure smooth installation, flush with the wall. Overtightening will cause it to break.
Step 4: Adjust the screw
After hanging the object, remove the screw. Once you find the screw, you need to manually adjust it with your fingers to make sure it is tight.
You will also need to tighten it down with a Phillips screwdriver once it is just over a quarter of an inch away from the wall. This way you don't have to worry about the screws protruding too much or pushing far away from the wall when you hang your item on them.
Frequently Asked Questions - Frequently Asked Questions
Can a screw be driven into a wall?
Screws must not be driven directly into the wall. Large paintings require secure mounting for the paintings. A screw inserted into a wall without an anchor cannot be permanently held in place. It will pull out sooner or later.
Why won't my screws stay in the wall?
Screws drilled directly into drywall often leave behind drywall that needs to be secured. If you can't find wall studs in the right places to support your fixtures, you may need to put in anchors. However, the anchors can move. No matter how strong other anchors are, wood holds up better.
Should I use a nail when screwing into the wall?
It is not necessary to make a recess on the wall with a nail, but if desired, it is permissible. As you start screwing the drywall anchor into the wall, use the recess to hold the tip of the drywall anchor.
Take a look at some of our articles below.
- How to screw into concrete without a puncher
- How to knock a nail out of a wall without a hammer
- How to hang a picture on a brick wall without drilling
Video link
