Replacing the fingers and anthers of the VAZ 2114 caliper
Uncategorized

Replacing the fingers and anthers of the VAZ 2114 caliper

26.05.2022 /

On all cars of the tenth family, including VAZ 2114, 2115 and 2113, there are problems with the brake system, such as wear of the caliper guide pins. As a result, the following problems may arise:

  1. Knocking and rattling from the caliper side on uneven roads (especially on dirt roads or gravel)
  2. Uneven wear on the front brake pads where there is noticeably more wear on one side than on the other
  3. Jamming of the caliper bracket, which can lead to an emergency
  4. Decrease in braking efficiency VAZ 2113-2115

To solve this problem, it is necessary to revise the caliper, namely, to replace the anthers and guide pins. Also, it is imperative to lubricate the fingers with a special compound.

So, to perform this repair you will need:

  • Key for 17 and 13 mm
  • Brake cleaner
  • Caliper Grease
  • Flat screwdriver

If you want to get acquainted with a step-by-step video and photo review, then you can watch it on the website remont-vaz2110.ru in the material: VAZ 2110 caliper revision... The main points on this repair can be found in the article below.

Replacing the guide pins of the calipers and their anthers on the VAZ 2114-2115

The first step is to raise the front of the machine with a jack. After that, remove the wheel and use a flat-blade screwdriver to bend the locking washers of the caliper bolts.

Then we unscrew the two mounting bolts at the top and bottom, as shown in the photo.

how to unscrew the caliper mounting bolts on the VAZ 2114, 2115 and 2113

Next, we squeeze the brake cylinder with a screwdriver, inserting it between the bracket and one of the pads.

compress the brake cylinder on VAZ 2114, 2115 and 2113

Then you can lift the cylinder with the bracket up, as shown below, and take it to the side so that it does not get in the way.

raise the caliper up on the VAZ 2114 and 2115

And now you can easily remove the caliper pins, both from above and below, with minimal effort.

replacement of the guide pins of the caliper on the VAZ 2114

Then we clean our fingers from the old grease with a special tool or buy a new one. Also, it is necessary to install a new boot if the old one is damaged.

cleaning the brake system on VAZ 2114, 2113 and 2115

We apply a special grease for the calipers on the finger and under the boot, as shown in the photo. Then we put our finger in its place to the end so that the boot is securely fixed.

grease for VAZ 2114 calipers - which is better

Now you can assemble the entire structure in the reverse order, and do not forget to press the brake pedal several times before leaving the place of repair so that the pads take their position in the guide.