Tire pressure sensor Kia Sorento
Not everyone knows where the Kia Sorento pressure sensor is located. In fact, there are only 4 of them and they are put on wheels. If the tire pressure sensors of the Kia Sorento Prime detect a lack of air, the driver will see a corresponding signal on the instrument panel - an indicator.
Consider how to remove and install tire pressure sensors on a 2020 Kia Sorento.
- Park the car on a firm, level surface.
- Make sure the first gear is engaged and the vehicle is not moving.
- Remove the valve core and let the air out of the tire.
- Disassemble it using a special bracket. Disassembly should begin at a location that will be approximately at a right angle from the location of the valve. In this case, the support guide should not be too deep. The bracket cannot come into contact with the valve, so do not touch it when disassembling.
- Remove the tire by turning the wheel clockwise.
- The air release valve may change its position during extraction, please pay attention to this. It must be correctly positioned.
- Press the valve against the edge of the disc and, maintaining a fixed position, tighten the nut.
- Install the valve on the disc so that its sealing washer fits into the hole.
- Holding the valve body with two fingers, press it axially with the third finger.
- Once installed, the laser marking must be legible.
- When the valve is fully seated in the disc rim, screw on the outer nut.
Now you know how to install a Kia Sorento Prime pressure sensor. But if you are not confident in your abilities, contact the experts. This work will not take much time and will not require large financial investments.
