1. Remove the ground cable from the battery. |
2. Disconnect the electrical connectors from the intake air temperature sensor and hot air mass meter. |
3. Remove the crankcase ventilation hoses. |
4. Disconnect the coolant supply hoses from the engine air intake, hot air roulette, and the air intake on top of the air cleaner and throttle body. |
5. Using a screwdriver, loosen the mounting brackets for the injectors of the first and fourth cylinders on the connecting strips and at the same time lift the strips. There are six connections on the back of the strips, four of which are for fuel injectors. |
6. Disconnect the electrical wires of the knock sensor from the connecting plate. |
7. Tie a piece of wire 1 m long to the electrical connector of the knock sensor. |
8. Remove the knock sensor from the cylinder block (see figure). |
9. Untie the excess wire from the electrical connector of the knock sensor. |