How to add oil to a car gearbox?

Gear oil does a very important job and is paramount to the proper operation of the system. It is important that you always keep an eye on the transmission fluid level and add or change oil as needed.

Automatic transmissions aren't that bad, and they're not here to supplant manuals. This is a revolutionary innovation that, unlike manual ones, will be used in electric vehicles.

However, both types of transmissions need to be looked after and their respective services must be performed in order to prolong their service life. If the transmission fails, the car is unable to move.

Automatic transmission oil changes services range from every 60,000 to 100,000 to 30,000 miles, but more frequent changes won't hurt, and on a manual transmission, most manufacturers recommend changing the transmission fluid every - miles.

Most people can make the decision to have the transmission fluid replaced or added by a mechanic. However, any of us can also change the gear oil. They just need to know the correct steps to properly change the transmission fluid.

Therefore, here we will tell you how to add oil to the gearbox of your car.

1. First you should check how much transmission oil is in your transmission. You just need to park your car and apply the parking brake. Sometimes a neutral gear may be required, depending on what is written in the owner's manual. Don't forget that the place where you park your car should be flat and level.

2.- Open the hood, find the gear oil tube and dipstick. The probe goes inside the pipe. When removing, pay attention to the liquid level. If it stopped between the "Finish" and "Add" marks, then everything is in order. But if it is below the Add mark, then you need to add transmission fluid.

3.- If you need to add oil, you can continue with this step. You will need two things: transmission fluid and a funnel. You need to make sure that the oil you buy is recommended by the car manufacturer.

4.- Start adding fluid to the gearbox. This can be done by placing a funnel in the transmission fluid line and then carefully pouring the transmission fluid into it. Only add a little liquid at a time to avoid overfilling. Between filling intervals, check the oil level with a dipstick.

5.- After reaching the level full, Take out the funnel. With the engine running, change all gears. Keep the engine idling to allow the new fluid to warm up and circulate through the transmission.

: