How to install a TV tuner in a car
Auto repair

How to install a TV tuner in a car

08.11.2022 /

Modern technology has greatly improved comfort and technology, and it is now possible to watch DVDs and TV in the car to entertain children and impress passengers. Installing a TV tuner can provide access to digital TV signals that can be viewed in the car. These tuners require either a monitor already installed or the purchase of a kit that includes a monitor and receiver.

This article will show you how to install a TV tuner in your car if you already have a monitor installed.

Part 1 of 1: Installing the TV Tuner

Necessary materials

  • A set of tridents
  • Screwdrivers
  • TV tuner kit with installation instructions
  • screwdrivers

Step 1: Choose a TV tuner kit. When buying a tuner kit, make sure it includes all the necessary installation materials such as wiring and instructions.

It is recommended to check if the kit will work with the existing monitoring system already installed in the car. This may require the purchase of a kit of the same brand as the monitor.

Step 2: Disconnect the battery. The first step is to disconnect the negative battery cable. This is done to avoid power surges and as a protest to the installer.

Make sure the negative cable is positioned so that it cannot touch the terminal during operation.

Step 3: Find a place for the TV tuner. Next, you will need to decide where the TV tuner will go. It should be in a protected, dry location where cables can be conveniently connected to it. A common place is under the seat or in the trunk area.

Once a location has been selected, it should be prepared for installation. The installation guide may have specific location instructions depending on the make and model of your vehicle.

Step 4: Install TV Tuner. Now that the position is ready, install the TV tuner in the selected location. The device must be secured in some way, whether by tie-down with zip-ties or screwing into place.

How the device is attached depends on the vehicle and kit to kit.

Step 5 Connect the TV tuner to a power source.. The TV tuner must be powered by the car's 12-volt power supply to work.

Locate the vehicle's fuse box that contains the auxiliary power fuse. Unless otherwise specified in the instructions, this fuse will be used.

Connect the wire to the fuse and run it back to the TV tuner.

Step 6: Install the IR Receiver. The IR receiver is the part of the system that picks up the signal. This will be installed somewhere where it can reach the signal.

Dash is the most common place. If the installation guide lists an alternative path, try that first.

The receiver wires must then be routed to the tuner box and connected to it.

Step 7: Connect the tuner to the monitor. Run audio/video wires to your existing monitor and connect them to the appropriate inputs.

Wires should be hidden as much as possible.

Step 8Check your device. Reinstall the negative battery cable that was disconnected earlier. Once vehicle power is restored, turn on the monitor first.

After turning on the monitor, turn on the TV tuner and check it.

Now that you have a TV tuner installed and working in your car, there is no excuse not to take the car on a pleasant journey. With a TV tuner, you can have hours of entertainment.

If you have any questions during the installation, you can always ask the mechanic a question and get a quick and detailed consultation. Qualified AvtoTachki specialists are always ready to help.

Add a comment