Replacing the rear brake cylinder on a VAZ 2110

Usually, if the rear brake cylinder fails on VAZ 2110 cars, a decrease in the level of brake fluid in the tank can be observed. This is due to a violation of the tightness of the piston and its rubber band. To eliminate this problem, it is necessary to replace the cylinder with a new one.

There is nothing complicated in this procedure, and to complete it you will need the following tools:

• 10 head with ratchet and crank
• Special wrench for unscrewing the brake pipes (the so-called split wrench)

To begin with, you need to remove the brake drum and rear pads, since otherwise you cannot get access to the cylinder.

After that, from the back side, unscrew the tube that fits to the cylinder with a split wrench:

To prevent the brake fluid from leaking out, you can plug the end of it for a while. Then we take the head with the knob and unscrew the two fastening bolts, again from the back side, as is more clearly shown in the photo below:

After that, you can safely remove the rear brake cylinder VAZ 2110 from the outside, since it is no longer attached to anything. The price of a new VIS production part is about 300 rubles per piece. If you change in pairs, then naturally you will have to pay about 600 rubles. Installation is carried out in the reverse order. If, after everything new has been installed, the braking efficiency has decreased, and when you press the brake pedal, it sinks more than necessary, it is necessary to pump fluid through the system.