Chevrolet Aveo speed sensor

Speed ​​sensors ChevroletAveo 1.2-1.4

The Chevrolet automobile company has a large circle of fans, consisting of people who care about the quality and reliability of products. The model range of this company is very wide, in addition, all cars are produced with a guarantee of reliability and quality. Among all models, Chevrolet Aveo can be singled out separately.

The advantages of this model are expressed in the following:

• practical meaning;
• reliability;
• and low cost.

You should know

There is not a single complex system in the Chevrolet Aveo. The car was originally conceived as simple. That is why any breakdown of the car can be repaired with your own hands, without contacting specialized services to specialists.

Spare parts

Parts for this car are the only thing that requires special attention. They must be purchased from trusted sources or from an authorized Chevrolet dealer. Otherwise, there is a possibility of acquiring low-quality products that are unsuitable for use.

Speed ​​sensor

Like any vehicle, the Chevrolet Aveo (1,2–1,4) is prone to breakdowns. This can happen both through the fault of the owner, and due to the breakdown of some part.

In this car, the speed sensor most often breaks. The reasons for the arrival of the part in a state unsuitable for work are varied and ambiguous. However, it should be noted that the repair will not take much time and will not require much effort.

Dismantling

The first thing to do is remove the sensor. This is necessary to start the repair.

For disassembly, you do not need to remove any additional protection or something like that. It should also be noted that the speed sensor on the Chevrolet Aveo (1,2–1,4) is installed vertically. This must be taken into account in the analysis.

There are cables at the top, so the exact speed indicators are really displayed.

To remove this part, you will need:

• disconnect the clamps that are attached directly to the sensor itself;
• after disconnecting the latches, the part must be unscrewed (here you need to be more careful, since it is unscrewed counterclockwise - by scrolling in the other direction, subsequent removal will be difficult and require additional effort).

If the Chevrolet Aveo sensor is too tight, you can use the inspection hole. On the car body there are places for easy access to this part - from under the bottom.

At the end of the disassembly, it will be necessary to remove the component cover, on which specialized markings can be found.

At first glance, removing the cover may seem like a daunting task, but in practice, everything is very different:

• one end of the cap must be pry off with a screwdriver;
• after that, with a sharp movement of your hand, without much effort, remove it.

The only thing that is needed until the repair is completed is internal welding.

Repair

The problem is simple:

• it is necessary to carefully unsolder the problematic part (in most cases, these are the lower tracks of the vertical board, which break for ambiguous reasons with priority factors in the form of rain and snow);
• broken tracks must be properly soldered.

The final look of the board doesn't matter, so you don't have to decorate everything.

Also to consider: If you are new to soldering and are new to soldering, the best option is to seek help from someone who is familiar with soldering.

Assembly

After performing all the manipulations, the sensor can be assembled and repaired.

Assembly is much easier than disassembly - all the steps above just need to be repeated in reverse order.